• News
• Technic

1 cutter trend of the times necessary to concentrate on work, not only to keep a clear head, but also to rational operating a power tool. Prohibited tired, drinking or doping, drug operation after the cutting machine.
2 power lines must be secure, is strictly prohibited without permission Luanla, carefully placed the power cord, do not be cut off. Must be carefully checked before use equipment performance to ensure that all parts intact.
3 put the right clothes, not wear loose clothing, not wearing jewelry or long hair, wear gloves and cuffs is strictly prohibited without deduction and operations.
4. Workpiece to be holding firm, is strictly prohibited without the workpiece clamping tight to start cutting.
5 is strictly prohibited in the wheel plane, burr grinding of the workpiece, to prevent the grinding wheel to shatter.
6 cutting operation must be a positive deviation from the grinding wheel, and wear protective glasses.
7 Do not use the grinding wheel has been incomplete, cutting should be to prevent Mars scattered, and away from flammable materials.
8 when clamping the workpiece clamping smooth solid, protective shield must be installed correctly, the boot empty after clamping operation inspection, without vibration and abnormal noise.
9 half-way cut pieces or new wheel replacement films, do not tighten the nut with excessive force, to prevent the saw blade or grinding wheel crack accidents.
10 must be stable grip the vertical cutting force under the uniform hand-cut, and the fixed end to a solid and reliable.
11 shall not attempt to sawing or clamping small workpieces with a serious edge profiles.
12 In order to improve efficiency. With support for single or multi-sawing, be sure to do a good job supporting fixture positioning.
13 may not be strong sawing operation, the motor speed to be cut before you can reach full speed.
14 does not allow any person standing behind saws, power, rest or leave the workplace, they should immediately cut off the power.
15 does not stop when the blade from the saw or the workpiece may not release any lift a hand or arm.
16 shall not operate when the guard is not in place, not from the hand on the saw blade 15 cm or less. Not lean over or around the saw, when the body Xiece 45 degrees is appropriate.
17 appear unusual sounds, immediately stop the examination; repair or replacement parts must be cut off the power before, and so saw a complete stop.
18 use in wet areas such as cutting machine work, must stand on dry insulating mats or on the board. Climb or explosion-proof hazardous area must be prepared to use safety precautions.
19 shakes and other equipment failures, repairs should be immediately shut down, sick and drink operation is prohibited, forbidden to wear gloves when operating. If the operation causes dust, wear a mask or face shield.
20. Finished processing power should be shut down and do a good job of cleaning equipment and the surrounding space.