• News
• Technic

Even in line with the wheel of the safety inspection requirements, if it is safe in use, the actual use of the wheel depends in large part the sea and the correct method of operation.

       1, before the start grinding machines, machine tools, the first of the machine tools and protective equipment and a variety of action reset switch has been adjusted in place and solid.

2, before to start the trimming and the use of abrasive wheels, the wheel with a protective cover (protective cover at least covering half of the grinding wheel diameter), work speed to idle for 3-5 minutes.

3, the machine starts, the operator can not directly face the wheel stand.

4, does not allow the workpiece is forced to squeeze into the grinding wheel, grinding pressure or feed excessive.

      5, the grinding, the operator should wear good safety glasses or other similar security products.

      6, dressing, or use the wheel, the contact to be playful. If necessary, re-trim wheel.

      7, do not shield not in place before starting the machine.

      8, do stationary wheel is immersed in liquid.

9, do not continue to use the wheel without finishing and surface passivation.

10 is strictly prohibited mandatory grinding resulting in machine motor slows significantly or hot so that the workpiece.

11, prohibited the wheel for its design does not match the other operations, such as side grinding.

12 is strictly prohibited to apply force on the wheel so that it is forced to stop turning.

13, before the wheel stops turning, first grinding fluid off, so as to avoid the wheel out of balance.

      14, the trim wheel, you must ensure that the diamond pen reset after processing.

15, mainly to prevent the wrenches and other foreign matter mixed in the work area